![]() The PVC elbows were ~$2.00 each at the hardware store. So,when choosing your container, be sure to note the thickness and quality of the plastic. A hundred pounds is a lot of weight pushing outwards on the side of the container. This particular container cost me around $12 at Walmart, and is large enough to hold two 50-pound bags of chicken feed, with room to spare. Still, it didn't take her very long to figure it out! My turkeys especially love these types of feeders. You can see my hen is not pleased with the "new big scary thing" in her coop. Our area is all orchards, meaning there are a lot of rodents around to attract! That's why I wanted the edges of the feeder ports to be high enough that I wouldn't be feeding a new generation. Make sure it's low enough that your hens can easily reach, but not so low that it will attract mice or other pests into our coop. Finally, place the feeder, and fill it up. To prevent the weight of the feed from pushing the elbows out, let dry overnight and do a second coat. There is some leeway as to hole size because the caulk will fill small gaps. Then, use your finger to "moosh" the caulk in for a better seal, and let that dry completely. Next, caulk the outside of the elbows, and let it dry. Carefully caulk the inside of the bends, to prevent them from slipping out. Here we have snugged the elbows into the feed tub. ![]() Once all the holes are cut, fit the PVC elbows into the holes like so: Using other methods to make the holes for your waste free feeder can leave rougher edges that don't fit snugly around the pipe elbow. We found it was better to let the saw spin and warm up the plastic a bit, before pushing the drill bit through.Ī hole saw makes a nice, clean cut. As always, safety first!Īs you drill, be careful not to push too hard, as the plastic can crack. Put your safety goggles on! A hole saw is a drill bit designed so you can cut perfectly round holes with your drill. Step 2: To make the holes, we used a 3.5" hole-saw. ![]() You want the bottom of the elbows to be at least one inch above the bottom of the feeder, so the chickens have a "well" to peck from. Step 1: First, use a level to measure where the elbows will go for your waste free feeder. My husband wanted to help, which was great, because it was easier for me wrangle munchkins and take pictures! ![]() My helper-dog is on the prowl for things he can interfere with! This is a pretty quick project, all in all, and can easily be completed by one person.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |